4-90
FACSIMILEâ–ºOTHERS FUNCTION
5
When scanning is completed, check
the number of original sheets.
The number that is displayed is the number of scanned
original sheets, not the number of scanned original pages.
For example, when 2-sided copying is performed using one
original, the number "1" will appear to indicate that one
original sheet was scanned, not "2" to indicate the front-side
page and the reverse side page.
6
Tap the [OK] key to start transmission.
If this function is combined with [Job Build], the count result is displayed after the [Read-End] key has been tapped.
If the displayed number of original sheets is different from the actual number of sheets:
Tap the [Cancel] key and then tap the [OK] key in the message screen to clear all scanned data. Scan settings and
destination settings will not be cleared. Insert the original sheets in the document feeder tray again and tap the [Start]
key to re-scan.
Exposure
AAA AAA
Original
Resolution
Job Build
Original Count
Slow Scan Mode
Others
Address
Sending History
Call Search Number
Call Program
Call Registered settings
Direct TX
Verification Stamp
Send Same Image
as Fax Address
Scan Size
Auto Auto
reception memory
100%
100%
Send Size
Start
CA
Preview
Mixed Size Orig.
Auto
Super Fine
8½x11 8½x11
0pages of original (Pg.No.1)
have been scanned.
Send the scanned data?"
Cancel OK
To Next Page
Loading...
Need help?
General
