Sharp MX-M7570 - Page 805

8-9
SYSTEM SETTINGS►SETTING MODE LIST
*1 Appears when [LDAP] is set in "Authentication Settings".
*2 Appears when " Settings (administrator) " - [Sharp OSA Settings] → [External Accounting Application Settings] →
[Set Authentication Server (Server 1)] is enabled.
*3 This setting is configured in setting mode on the web page.
*4 This setting is configured in setting mode on the machine.
● User Count No Yes
1-64
 View User Count – No Yes
 Save User Count*
3
– No Yes 1-65
● Billing Code Setting No Yes
1-81
 Administration Settings – No Yes
 Use Billing Code Disabled No Yes
 Default Code Setting Default Code No Yes
 Remember Billing Code Between Modes Disabled No Yes
 Disable Change of Billing Code Disabled No Yes
 Apply Default Code when Billing Code not entered Disabled No Yes
 Disable Billing Code for Selected Applications No Yes
•Sharp OSA All Invalid No Yes
 Billing Code Display Name Setting No Yes
• Main Code Display Name Default No Yes
• Sub Code Display Name Default No Yes
 Main Code List – No Yes
 Sub Code List – No Yes
● Card Setting No Yes
1-66
 Card Area Setting No Yes
 Check System Code only in FeliCa User Area mode Disabled No Yes
 Check Facility Code in HID mode Disabled No Yes
 Importing from the setup file – No Yes
 Card Scan Test*
4
Disabled No Yes
 Card Type / Card Reader Settings No Yes
 Card Type / Card Reader 200 No Yes
 Card Reader Device Registration*
4
200 No Yes
Setup Items Factory default setting U A Page