Sharp SD-AT50 - Connecting the Satellite Speakers

SD-AT50
DX-AT50
Plug in with the rising
side facing to the left.
(Subwoofer/amplifier unit)
Label
~
~
~ Cord holder
(Satellite speaker)
Speaker terminals
o 0 0 Red Tube
~
\
o Black
~j ~~
~ ~+~0
Caution:
• Make sure to connect the speakers after unplugging the DVD player and the sub-
woofer/amplifier unit.
• Insert the speaker plug fully with the rising side facing to the left.
• Hold the speaker plug when removing it from the subwoofer/amplifier unit. Pulling
the cord may cause malfunction to the subwoofer/amplifier unit.
• Do not mistake the
ffi and 8, and right and left terminals of the speaker cords. (The
right speaker is placed on the right when you face the system. See page 16.)
• Never short-circuit the speaker cords. If the
speaker cords are short-circuited, the protec-
tion circuit is activated and the system enters
the stand-by mode.
In such a case, check that
the cords are properly connected before turn-
ing the power on again.
• Only the supplied speakers should be used with this product.
• Do not stand or sit on the speakers. You may be injured.
Binding cords:
Tie the cords connected to the subwoofer/amplifier unit with a cord holder.
- Connecting the satellite speakers
Insert the speaker plugs into the subwoofer/amplifier unit according to the color coding.
Connect the speaker cords to the satellite speakers first and then to the sub-
woofer/amplifier unit.
Center speaker
• All satellite speakers provide the same performance.
Their positions can be exchanged with one another.
E-12