Sharp SD-AT50 - Changing the Registration in the Remote Control

Changing the registration in the remote control
SD-AT50
DX-AT50
Sharp's TVs can be operated with the remote control of this system without register-
ing the operation (except for some models). (See page 47.) You can also operate
TVs of other manufacturers by changing the registration in the remote control.
1 While holding down the TV ON/STAND-BY button, press the TV
CHANNEL
A button.
2 Enter the manufacturer setting number (2 digits) with the direct
number buttons (0 - 9) and press the TV ON/STAND-BY button.
The setting is registered and the TV can be operated with the remote control of
this system.
(*): The default manufacturer number is
01 (SHARP).
Notes:
• As for manufacturers with 2 or more setting numbers, select one of the numbers
with which you can operate the TV.
• The number will not be set unless the registration is completed within 30 seconds.
In that case, try registration again.
• Once you set a number, the number previously memorized will be canceled.
• After replacing the batteries
in the remote control, the registered number may
automatically be set to
01 (SHARP). If it occurs, register the desired number
again.
• Registration cannot be executed depending on TVs. Even if numbers can be set,
some buttons may not work.
TV manufacturer
Setting
number TV manufacturer Setting number
SHARP
01 (*),02
EMERSON
37,38,39,40
PANASONIC
03,04,05
FISHER
23
JVC
06,07,08
GE 41,42
SONY
09
GOLDSTAR
43
MITSUBISHI
10,11,12,13
MAGNAVOX 44,45
HITACHI 14,15,16,17
RCA 46,47,48,49
TOSHIBA
18,19
ZENITH
50,51
PIONEER
20
PHILIPS 52,53
SANYO 21,22,23,24 THOMSON 54
FUJITSU
25
GRUNDIG 55
AIWA
26
FERGUSON 56, 57
FUNAI
27,28, 29, 30, 31, ITT NOKIA 58,59
32
SAMSUNG
33,34,35,36
LOEWE
60,61
II Changing the TV registration
Use buttons on both sides of the remote control.
0@@)
0®®
®®®
@9~
[Back]
[Front]
TV
.-_ .............. "
•( /'... I I
• CHANNEL I
I I
I ONI •
I STAND-BY
•( I
_ ..................... .J
E-40