Sharp SD-AT50 - Speaker Settings

Measure the distance between each speaker and the listening position, and set
the speaker delay.
In the left illustration, the front speakers, the
center speaker, and the subwoofer are posi-
tioned at 10 feet (3.3
m), and the surround
speakers are at 12 feet
(4 m) from the listen-
ing position.
CT
Note:
The recommended size is set for the supplied speakers. See the upper table on page
42 for other speakers.
Caution:
To set the speaker size, set the sound mode to "STANDARD".
II Speaker delay setting
When some of the speakers are at a different distance from the listening point, you
can select the speaker delay to make it seem as though the speaker distances are
the same.
Note:
See the lower table on page 42 for the adjustable range.
1
Press the SETUP AMP button, and the ~ or ~ button to select liSP
DELA VII. Then press the ENT button.
2
Within 30 seconds, press the ~ or ~ button to select the desired
speaker.
3
Within 30 seconds, press the •
lLI
II, t_ T
j
or • button to select the distance
fLf'
,
and press the ENT button.
'L
• You can change the distance in 1 feet (0.3 m) steps.
• To set the distance of other speakers, repeat the operation from step
2.
®
0
@9
®
C!)
RETURN
@
SET
UP
AMP
0
II Speaker size setting
You can change the sizes of the speakers if they are not supplied ones.
Speaker settings
The speaker settings are not displayed on the TV screen.
[Back]
1
Press the SETUP AMP button, and the ~ or ~ button to select liSP
SIZE
II
. Then press the ENT button.
2
Within 10 seconds, press the ~ or ~ button to
I I
I I
illtctJ R}
select the desired speaker.
The indicators of selected speakers flash.
/d:E~' 1\
I!§]ID~
3 Within 10 seconds, press the. or • button to select their sizes.
To set sizes of other speakers, repeat the operation from step 2.
SD-AT50
DX-AT50
E-41