Sharp SD-AT50 - Speaker Level Setting; Sd-At50; DX-At50

SD""AT50
DX-AT50
- Test tone
3
Within 10 seconds, press the A or ~ button to adjust the level.
-1-
(*) indicates the default setting.
- To end the speaker setting
Press the RETURN oe button twice.
Default settings:
Delay - - - 6 feet (2 m)
Level - - - 0 dB
Speaker type
Speaker size
Front speaker (Left, Right) F-LARGE
Large diameter
F-SMALL
*
Small diameter
Center speaker C-LARGE
Large diameter
C-SMALL
*
Small diameter
C-NO
OFF
Surround speaker (Left, Right)
S-LARGE
Large diameter
S-SMALL
*
Small diameter
S-NO
OFF
Speaker type Delay range
Level range
FL Front speaker (Left) 1 - 29 ft
- 6 dB -
+ 6 dB
CT Center speaker 1 - 29 ft
- 6 dB -
+ 6 dB
FR
Front speaker (Right)
1 - 29 ft
- 6 dB -
+ 6 dB
SL Surround speaker (Left)
1 - 29 ft
- 6 dB -
+ 6 dB
SR
Surround speaker (Right) 1 - 29 ft
- 6 dB -
+ 6 dB
SW
Subwoofer 1 - 29 ft
- 10 dB -
+ 10 dB
~
SR
---.,..---". FR
---- ... CT
FL
t
SW ... ~---- SL ... ~----
You can check the sound output from the speakers. (If the speaker levels are not
equalized, they can be adjusted, too.)
1 Press the SETUP AMP button, and the ~ or ~ button to select liSP
LEVEL". Then press the ENT button.
• You can adjust the level at 1 dB intervals.
• To adjust the levels of other speakers, repeat the operation from step
2.
Press the SETUP AMP button, and the ~ or ~ button to select "TONE".
Then press the ENT button.
The test tone will be heard from each speaker, in order, at about 2-second inter-
vals.
2 Within 10 seconds, press the ~ or ~ button to select the desired
speaker.
If the levels are not equal:
While the test tone sounds, press the A or ~ button to adjust the level.
You can select a speaker by pressing the
~ or ~ button.
Note:
If NO (OFF) is selected for a speaker in the speaker size setting, no test tone will be
heard from it.
- Speaker level setting
If sounds from the speakers are uneven, you can equalize them by adjusting the
speaker levels.
Notes:
• Adjust the level of the subwoofer if the sound from it is distorted.
• See the lower table
on the right for the adjustable range.
E-42