EasyManua.ls Logo

Sharp SD-AT50 - Special Notes

Sharp SD-AT50
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SPECIAL NOTES
(for
Users
in
the
U.S.A.)
The exclamation point within
an
equilateral triangle is
intended to alert the userto the presence of important
operating and maintenance (servicing) instructions
in
the literature accompanying the appliance.
The lightning flash with arrowhead symbol, within
an
equilateral triangle,
is
intended to alert the user to the
presence of uninsulated "dangerous voltage" within
the product's enclosure that may
be
of sufficient mag-
nitude to constitute a risk of electric shock to persons.
WARNING:
TO
REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK,
DO
NOT EXPOSE THIS APPLIANCE
TO
RAIN OR
MOISTURE.
Note
to
CATV
system
installer:
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the National Electrical Code that provides guidelines for proper grounding and,
in
particular, specifies that the cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry as practical.
NOTE
This equipment has been tested and found
to
comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in
a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and,
if
not in-
stalled and used
in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is
no
guarantee that interference will not oc-
cur
in
a particular installation. If this equipment does cause harmful interference to ra-
dio or television reception, which can
be
determined by turning the equipment off and
on, the user
is
encouraged to try to correct the interference by one or more of the fol-
lowing measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into
an
outlet
on
a circuit different from that to which the re-
ceiver is connected.
Consult the dealer or
an
experienced radion-V technician for help.
WARNING
FCC Regulations state that any unauthorized changes or modifications to this equip-
ment not expressly approved by the manufacturer could void the user's authority to
operate this equipment.
CAUTION:
THIS PRODUCT
IS
A CLASS 1 LASER PRODUCT.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY
RE-
SULT
IN
HAZARDOUS RADIATION EXPOSURE.
AS
THE LASER BEAM USED
IN
THIS PRODUCT
IS
HARMFUL TO
THE EYES,
DO
NOT ATTEMPT
TO
DISASSEMBLE THE CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL
ONLY.
FOR YOUR RECORDS
For your assistance
in
reporting this unit
in
case of loss or theft, please record
below the model number and serial number which are located
on
the bottom or
rear of the units.
Please retain this information.
Model
number
Serial
number
Date
of
purchase
Place
of
purchase

Table of Contents

Related product manuals