Sharp SD-AT50 - Error Indicators and Warnings

Error indicators and warnings
When you load an unplayable disc or fail to perform operations properly, the following
messages are displayed on the AV control unit, the DVD player and the TV screen.
AV control unit display
Meaning
I
TI'-',
""-
I
• Place the system away from noise source or plug the
.1-'.:J'--
I "L]
AC power cords to other AC outlets. (*)
I CO __ oon::J
I
• The speaker is not connected properly.
LI' I" LIL
• The amplifier is defective.
Set the system to the stand-by mode and turn the
power on again. (*)
[ CO __ oon::J
I
• The amplifier is defective.
Set the system to the stand-by mode and turn the
LI' I" LI_I
power on again. (*)
[CO __ OO
1 '--I
I
• The amplifier is defective.
Place the system away from noise source or plug the
LI' I"
AC power cords to other AC outlets. (*)
[COllI
,,'-'1
• The cooling fan on the back of the subwoofer/ampli-
,
fier does not run due to foreign objects caught in it.
I I" "
LLIL'-'
Set this subwoofer/amplifier unit to the stand-by
mode and remove the foreign objects around the
fan.
['I Inc
"-"""
• The digital audio input jack is not connected proper-
"'L'_'
'C" "'--'L
Iy.
• Unspecified signal is received and cannot be recog-
nized.
[
,- '-',TI' ,-
I
• The system connection cable is unplugged.
=,-- L'--' ... [ILC
I
T'-"Iln
I
• The temperature is too high.
, CI ,,--
Set the system to the stand-by mode and wait a
while.
(*): Should the same message appear even if the DVD player and the subwoofer/am-
plifier unit are unplugged and plugged in or are set to the stand-by mode and on
again, contact your local dealer where you purchased the system.
DVD player display
Meaning
• The disc is not loaded.
I
- -
-
-
-I
• The disc is scratched or dirty and cannot be recog-
nized.
• The disc is loaded upside down.
TV screen Meaning
The disc cannot be played with this system or
IDisc Error:
I
it is loaded in an incorrect way.
Playback feature may not be available
on this Disc.
Please eject the disc.
The region number of the DVD is not 111
11
or
IRegion Error:
I
IIALL
II
.
Playback is not authorized in your region.
Please eject the disc.
I
~I
The disc does not support the operation de-
scribed in this operation manual.
II Condensation
Sudden temperature changes, storage or operation in an extremely humid environ-
ment may cause condensation inside the cabinet (laser pickup, etc.) or on the trans-
mitter on the remote control.
Condensation can cause the system to malfunction. If this happens, leave the power
on with no disc in the DVD player until normal playback is possible (about 1 hour).
Wipe off any condensation on the transmitter with a soft cloth before operating the
system.
SD-AT50
DX-AT50
E-48