Caution:
• Close the disc tray when
it
is
not
in
use. Otherwise, dust may accumulate inside
and cause malfunction to the DVD player.
• The DVD player
is
slightly heated when used for a long time.
It
does not mean the
DVD player
is
damaged.
• When attempting to play discs with scratches or of a different region number, or
unplayable or restricteq (*1) discs,
an
error message will appear
on
the TV display
and the disc will not play.
(*1) Viewing
is
prohibited
on
some DVDs according to the audience age.
Notes:
• A safety feature automatically sets the system to the power stand-by mode if you
set the volume level too high while playing certain types of discs.
If
this happens,
lower the volume level and restart playback.
• Stop positions may be recorded
on
some discs. When you play such a disc, play-
back stops there.
• During
an
operation,
11(911
may appear indicating that the operation is disabled by
the disc.
• When the DVD player
is
left unoperated for more than 5 minutes after pressing the
stop button, a screen saver appears. Then, after additional 30 minutes, the player
enters the stand-by mode.
[Front]
DVD/CD
( •
1_llIIIiiIiiiiiiiriiiiiiiiiiiiii~
STILL/
PAUSE
(
..
I
II
To interrupt playback
Press the STILUPAUSE
II
button.
To resume playback from the same point, press the DVD/CD
~
button.
II
To stop playback
Press the DVD/CD • button.
II
To resume playback after stopping
(sequential playback) _
"CD,
You can resume playback from the point that the playback
is
stopped.
1 While the disc
is
playing, press the DVD/CD • button.
The system stores the point you stopped.
2 To restart play, press the DVD/CD
~
button.
Play resumes from the point you stopped.
To cancel the sequential playback:
Press the DVD/CD • button twice.
Notes:
• The sequential playback feature is disabled on some discs.
• Depending
on
the disc, playback may resume from slightly before the stopped
position.
II
Headphones
• Before plugging
in
or unplugging the headphones, reduce the volume.
• Be sure your headphones have a
1/8" (3.5 mm) diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance
is
32 ohms.
• Plugging
in
the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
• You cannot use the surround feature with headphones.
SD-AT50
DX-AT50
E-28
To Next Page
Loading...
