Sharp SD-AT50 - Page 25

Setting
Selectable parameters (* indicates initial settings.)
Description
LANGUAGE
AUDIO
ORIGINAL * Selects the language audible from the speakers.
I SET-UP
I
ENGLISH
ILANGUAGE CONTROLS
I
I'·AUDIO
ORIGINAL I
2 SUBTITLE OFF
SUBTITLE
OFF* Selects the subtitle displayed on the TV screen.
3.DiSC MENU
ORI~I~~AL
ENGLISH
4.PI.AVER [v1ENU
ENG •. bH
ISELECT:C/~ SET: ~I
EXIT: rmii.Ui CANCEL: ImimmJ
DISC MENU
ORIGINAL Selects the disc menu language.
ENGLISH *
PLAYER MENU
ENGLISH * Selects the initial or playback setting language.
FRANQAIS
DISPLAY TV ASPECT
4:3 LETTER BOX * The screen mode should
be set according to the connect-
I SET-UP
I
4:3 PAN & SCAN
ing TV type (for details, see page 22).
IDISPLAY CONTROLS
I
16:9 WIDE
!UV ASPECT 4:3 LETTER BOX I
2 PANEL DISPLAY ON
PANEL DISPLAY
ON*
Brightness settings for display (When set to auto, the light
3.ANGLE ICON ON
OFF
turns off during playback.)
4 .'\lJ'fO POWEFl OFF ON
AUTO
ISELECT:C/~ SET: ~I
EXIT: rmii.Ui CANCEL: ImimmJ
ANGLE ICON
ON*
Sets or cancels angle icon (E:b) display on the TV screen.
OFF
AUTO POWER OFF
ON*
The system automatically enters the stand-by mode when
OFF
no operation is entered for more than 35 minutes.
AUDIO DRC
OFF* *
Sets or cancels the control over the volume range.
(Digital output)
I SET-UP
I
ON
IAUDIO CONTROLS
I
* Do not change the
DOLBY DIGITAL
BITSTREAM* *-
Selects the type of a sound signal sent from the coaxial dig-
initial settings.
I'ORC OFF 'I
ital audio output jack.
2 DOLBY UIGIIAL BITSTRE;;M
DPCM
3 D"TS ON
DOWN SAt."lPlING AUTO
DTS
ON**
ISELECT:C/~ SET: ~I
OFF
EXIT: rmii.Ui CANCEL: ImimmJ
DOWN SAMPLING
AUTO * *
Converts the sound signal recorded by PCM of 96 kHz into
48 kHz
48 kHz.
96 kHz
PARENTAL PARENTAL LEVEL
ALL *
Sets the viewing restriction level of the DVD software.
I SET-UP
I
8 - 1
IPARENTAL CONTROLS
I
CHANGE
Please enter a 4-digit Password setting or change
I' .PARENTAL LEVEL
ALL
I
password.
2 CHf\NGE
114737
11
cannot be set as a password.
When you forget your password, cancel the current password
by pressing "473T
1
using the direct number buttons (0 - 9).
SD-AT50
DX-AT50
E-20