SD-AT50
DX-AT50
DOLBY PRO LOGIC
II
indicator:
• This indicator
is
lit when the 2ch signals are entered to extend them to the
5.1
ch
surround sound.
• Even the 2ch sound recorded with Dolby Digital will be extended to the
5.1
ch.
Notes:
• You can switch the audio while playing the disc of multiple types (Dolby Digital,
DTS, etc.) (page 34).
• When the surround mode is set to the standard or surround mode, the sound of
monaural signals
is
heard only from the center speaker.
• When the surround mode
is
set to stereo, the same monaural sound is reproduced
in
both the right and left channels.
• The surround indicator
is
lit according to the input audio source.
1 Front Left Signal Indicator
2 Center Signal Indicator
3 Front Right Signal Indicator
4 LFE (Low Frequency Effect) Signal Indicator
5 Surround Left Signal Indicator
6 Surround Monaural Signal Indicator
7 Surround Right Signal Indicator
DOLBY DIGITAL
lOTS
indicator:
The input signal is recognized automatically and the indicator lights
up.
o
o
Stereo
You can enjoy the great acoustic ef-
fects of the front speakers and sub-
woofer.
The STEREO indicator lights
up.
Surround
Dynamic sound
You can enjoy the normal surround with various scenes.
MOVIE: The bass level
is
increased for powerful sound effect.
MUSIC: You can enjoy lively sound by producing the articulate sound.
NIGHT: Soft but powerful sound
is
achieved even at low volumes.
Acoustic effect
This mode provides
an
expansive lis-
tening area by emitting 2-channel
sound.
The SURROUND indicator lights
up.
Standard
The maximum of
5.1
ch surround sound
is
reproduced to provide three-dimen-
sional effect. The system automatically
emits the
5.1
ch
sound according to the
recorded audio signal. .
The STANDARD indicator lights
up.
E-38
To Next Page
Loading...
