SD-AT50
DX-AT50
Timer play indicator
When the finish time is reached:
The system
is
set to the power stand-by mode automatically.
Note:
The timer operation is disabled with discs containing menus.
Reusing the memorized timer setting:
The timer setting will be memorized once it is entered. To reuse the same setting,
perform the following operations.
1 Turn the power on and press the TIMER button.
Set the AV control unit on time if "TIMER STANDBY" does not appear.
2 Within 10 seconds, press the ENTER button.
After the setting contents are displayed
in
order, the system
is
set to the timer play-
back stand-by mode.
Changing the timer setting:
Turn the power on, and repeat the operation from step 1
in
"S
e
tting the timer" (page
43).
Canceling the timer playback:
Timer playback
is
canceled by turning the power
on
while
in
the timer playback
stand-by mode. The same operation can be performed
in
the following procedure
without turning the power on.
1 Press the TIMER button.
"TIMER CANCELli will appear.
2 Within 10 seconds, press the ENTER button.
Timer playback will
be
canceled (the contents of the setting will not be canceled).
Caution:
• The contents of the setting will be erased
if
the system is unplugged or a power
failure occurs.
In
such cases, set the timer again.
• This system cannot set the timer of other equipment.
• When setting the timer playback using the digital tuner, TV or VCR, the connected
equipment should be set to timer playback at the same time.
,-""
"-,-,
L'--"
"LC-
L
Jt-
/ \
2 Within 10 seconds, press the
.....
or
~
button to select "TIMER CALL", and press
the ENTER button.
The system returns to the timer playback stand-by mode after the setting con-
tents are displayed
in
order.
When the start time
is
reached:
Playback starts automatically and the volume increases gradually.
The timer play indicator flashes.
1 While
in
the timer playback stand-by mode,
press the TIMER button.
To check the timer setting:
E-44
To Next Page
Loading...
