Sharp SF-2040 - Page 109

Sim. NO Sim. SUB Description
22
04 Total jam counter display
05 Total counter display
06 Developer counter display
07 Developer preset cycle counter display
08 RADF counter display
09 ADU counter display
10 Staple counter display
11 Developer adjustment time display
12 Drum adjustment time display
13 Key operator code display
14 ROM version display
15 Trouble memory display
16 Cassette paper feed counter display
24
01 Jam memory/total jam counter clear
03 Duplex counter clear
04 ADF/RADF counter clear
05 Staple counter clear
06 Developer adjustment time clear
07 Drum adjustment time clear
08 Cassette paper feed counter clear
25
01 Main motor system ON, toner sensor output display
02 Auto developer adjustment
06 Toner control A counter value setting
07 Grid correction setting for toner control A
26
01 Option setting
03 Coin vendor setting
05 Counter mode setting
06 Destination setting
07 Drum sensitivity setting
08 Lens focus setting
09 4/5 mirror characteristics setting
10 AE original density setting
27 01 PPC communication trouble
30
01 Paper sensor state display
02 Cassette size switch state display
41
01 Document size sensor check
02 Document size sensor adjustment
03 Document sensor light receiving level adjustment
42 ** Developer counter clear
43 ** Fusing temperature setting
44
01 Correction mode setting,
02 Drum mark sensor sensitivity adjustment
03 Image density sensor sensitivity adjustment
05 Test mode
06 Compulsory execution of process control
07 Drum mark sensor/image density sensor gain select check
09 Process control data display
11 Enters the copy aging mode to allow the following operation and setting.
12 Copying is performed without process control.
46 01 Exposure level adjustment
47 ** AE sensor characteristics setting
48
01 Front/rear magnification ratio adjustment, focus adjustment
02 Paper transport direction magnification ratio adjustment (scanner speed)
50
01 Lead edge image position adjustment, lead edge void adjustment (Calculation)
02 Lead edge image position adjustment, lead edge void adjustment (Measurement)
51 02 Paper buckle adjustment
52
01 ADU alignment plate adjustment value setting
02 ADU trail edge plate adjustment value setting
03 ADU drive clutch OFF time setting
53
01
RADF stop position adjustment
Normal paper, Single copy
02 Normal paper, Duplex copy
03 Thin paper, Single copy
04 Thin paper, Duplex copy
05 RADF resist sensor adjustment
06 RADF timing sensor adjustment
07 RADF repulsion sensor adjustment
08 RADF empty sensor adjustment
8 – 3