Sharp UP-700

193
TRAINING Mode Selection
Use the following procedure to select the training mode:
TRAINING mode
You will use the TRAINING mode if you need to train someone in machine operations without any change in
POS terminal’s memory. Reports are not available. When the training is completed, exit this mode and put
your POS terminal back into the normal mode of operation.
Program the item as follows:
• TRAINING MODE (Use the selective entry)
YES: Allows entering the training mode.
NO: Disallows entering the training mode.
NOTE
• All operations in the training mode are the same as the REG-
mode operations.
• In the training mode, the consecutive number is incremented.
• The cash drawer does not open in the training mode.
Items normally sent to the remote printers are not sent.