220
Removing a paper jam
Precaution: Be very careful with the manual cutter to avoid cutting yourself. Never touch the print
head immediately after printing, because the head may still be hot.
1.
Remove the printer cover.
2.
Pull the print head release lever all the way forward
(after it stops at one position, continue pulling forward
until it stops again and cannot be pulled forward any
further).
3.
Remove the paper jam. Check for and remove any
shreds of paper that may remain in the printer.
4.
Return the print head release lever to its original
position.
5.
Reset the paper roll(s) correctly by following the steps in
“Installing the paper roll”.
6.
Replace the printer cover.
Pull all the
way forward
To Next Page
Loading...
Need help?
General
