Sharp XV-Z17000

Connections
-21
Ensure that the computer is the last device to be turned on after all the connections are made.
Connecting to a Computer Using the RGB Cable
Connecting to a Computer
Note
• Refer to “Compatibility Chart” on page 70 for a list of computer signals compatible with the
projector. Use with computer signals other than those listed may cause some of the functions not to work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest
Macintosh Dealer.
• Depending on the computer you are using, an image may not be projected unless the computer’s
external output port is switched on. (e.g. Press “Fn” and “F5” keys simultaneously when using a
SHARP notebook computer). Refer to the specifi c instructions in your computer’s operation manual to
enable your computer’s external output port.
Computer
To RGB output terminal
RGB cable
(commercially available)
To COMPUTER/COMPONENT terminal
XV-Z17000EUS.indb21XV-Z17000EUS.indb21 2010/12/1711:16:192010/12/1711:16:19