Parameter Description
Parameter Description
138
If both P.288 and P.290 are 0, P.289 and P.291 will be displayed as 0. Both P.289 and P.291 are
read-only parameters.
Abnormal code corresponded alarm condition:
Abnormal
Number
Alarm
Code
Abnormal
Number
Alarm
Code
Abnormal
Number
Alarm
Code
Abnormal
Number
Alarm
Code
00 (H00)
No alarm
33 (H21)
OV2 64 (H40) EEP 160 (HA0)
OPT
16 (H10)
OC1 34 (H22)
OV3 66 (H42) PIDE 179 (HB3)
SCP
17 (H11)
OC2 35 (H23)
OV0 97 (H61) OLS 192 (HC0)
CPU
18 (H12)
OC3 48 (H30)
THT 98 (H62) OL2 193 (HC1)
CPR
19 (H13)
OC0 49 (H31)
THN 129 (H81)
AErr
32 (H20)
OV1 50 (H32)
NTC 144 (H90)
OHT
5.71 Accumulative Motor Operation Time Function (P.292, P.293)
P.292 “Accumulative motor operation time (minutes)”
P.293 “Accumulative motor operation time (days)”
Parameter Factory Setting Setting Range Remarks
292 0min 0~1439min ---
293 0day 0~9998day ---
<Setting>
• P.292 means the minutes of accumulative motor operation, execute P.998, shut off the power, and
the updated value cannot change the value of P.292. The only way to clear the accumulation of time
is to set P.292 to 0.
• P.293 is about the accumulative motor operation time in days. The updated value cannot be
modified by executing P.998 or power shutdown. To clear the accumulated time, make P.293=0.
5.72 Password Protection Function (P.294 and P.295)
P.294 “Decryption parameter” P.295 “Password setup”
Parameter Factory setting Setting range Remarks
294 0 0~9998 ---
295 0 2~9998 ---
<Setting>
• P.294 is the parameter that provides the decrypt function. P.294 will be zero if the decryption is
To Next Page
Loading...
Need help?
General
