Parameter Description
Parameter Description
42
5. Parameter Description
(1) Adjusting th
e output torque of motor (current)
5.1 Torque Boost (P.0, P.46) V/F ................................................................................................................... 45
5.11 Stall Prevention (P.22, P.23, P.66) ............................................................................................................... 56
5.40 Slip Compensation Coefficient (P.89) V/F .......................................................................................... 108
5.47 Zero-speed Function (P.151~P.152) V/F ............................................................................................ 114
5.48 Over Torque Detection (P.155~P.156, P.260) ........................................................................................... 114
5.73 Motor Control Mode (P.300 and P.301) .................................................................................................... 139
5.74 Motor Parameter (P.302~P.309) ................................................................................................................ 141
5.75 Sliding Compensation Gain (P.320) ......................................................................................................... 142
5.76 Torque Compensation Filter (P.321) ......................................................................................................... 142
(2) Output frequency limit
5.2 Range of the Output Frequency (P.1, P.2, P.18) ............................................................................................ 46
5.42 Frequency Jump (P.91~P.96) .................................................................................................................... 109
(3) V/F curve setting
5.3 Base Frequency and Base Frequency Voltage (P.3, P.19, P.47) .................................................................... 47
5.9 Load Pattern Selection (P.14, P.98, P.99, P.162~P.169) ................................................................................ 53
(4) Setting frequency by external terminal
5.4 Multi-speed (P.4~P.6, P.24~P.27, P.142~P.149) ............................................................................................ 48
5.10 JOG Mode (P.15, P.16) ............................................................................................................................... 56
5.28 Remote Control Function Selection (P.61) ................................................................................................. 95
(5) The setting of acceleration and deceleration time or mode
5.5 Acceleration/Deceleration Time (P.7, P.8, P.20, P.21, P.44, P.45) ................................................................. 49
5.8 Starting Frequency (P.13) ............................................................................................................................. 52
5.13 Acceleration/deceleration Curve Selection (P.29, P.255~P.258) ................................................................. 58
5.44 Programmed Operation Mode (P.100~P.108, P.111~P.118, P.121~P.123, P.131~P.138)........................... 110
5.46 The selection of positive and reverse rotation dead time (P.119) ............................................................. 113
(6) The selection and protection of motor
5.6 Electronic Thermal Relay Capacity (P.9) ..................................................................................................... 51
(7) Braking and stopping of the motor
5.7 DC Injection Brake (P.10, P.11, P.12) ........................................................................................................... 51
5.14 Regenerative Brake (P.30, P.70) ................................................................................................................. 61
5.31 Brake Selection (P.71) ................................................................................................................................ 98
5.64 DC Injection Brake Function before Starting (P.242~P.244) V/F ........................................................ 131
(8) Distribution and control of the external terminal’s function
5.21 Multi-function Output (P.40, P.64, P.74, P.85, P.120 and P.187) ................................................................. 86
5.22 Up-to-frequency Sensitivity (P.41)
............................................................................................................. 89
5.23 Output Frequency Detection (P.42, P.43) .................................................................................................... 90
5.24 AM Terminal (P.54~P.56, P.190, P.191) ...................................................................................................... 91
To Next Page
Loading...
Need help?
General
