Parameter Description
Parameter Description
43
5.29 Zero Current Detection (P.62, P.63) ............................................................................................................ 97
5.37 Multi-function Terminals Function Selection (P.80~P.84, P.86) ............................................................... 102
5.38 Multi-Function Control-Terminal Input Positive/Negative Logic (P.87).................................................. 107
5.39 Multi-Function Output Terminal Positive/Negative Logic(P.88) ............................................................. 108
5.49 External Terminals Filter Adjusting Function (P.157) .............................................................................. 115
5.67 Maintenance Alarm Function (P.261) ....................................................................................................... 136
(9) The monitor display and output signal
5.12 Output Frequency Filter Constant (P.28) .................................................................................................... 57
5.18 Speed Display (P.37, P.259) ........................................................................................................................ 80
5.45 Operation Panel Monitoring Selection (P.110) ......................................................................................... 113
5.52 Multi-function Display (P.161) ................................................................................................................. 116
(10) The motion selection when the power cuts out in the moment
5.25 Restart Function (P.57, P.58, P.150) V/F .............................................................................................. 92
(11) The motion setting when something unusual happened
5.30 Retry (P.65, P.67, P.68, P.69) ....................................................................................................................... 97
5.54 4-5 Terminal Disconnection Handling (P.184) ......................................................................................... 122
5.68 Vibration Inhibition Factor (P.286) ........................................................................................................... 136
5.69 Short Circuit Protection Function (P.287)................................................................................................. 137
(12) Running with energy saving
5.51 Energy-saving Control Function (P.159) V/F .................................................................................... 116
(13) The noise reducing of motor and electromagnetism
5.15 Soft-PWM Selection (P.31) ........................................................................................................................ 61
5.32 Carrier Frequency (P.72) ............................................................................................................................. 99
(14) The setting of analog input frequency and torque (terminal 2 and 4)
5.19 Voltage Signal Selection and Target Frequency (P.38, P.73, P.139~P.141) ................................................. 81
5.20 The Input Signal across Terminal 4-5 and the Target Frequency (P.17, P.39) ............................................ 85
5.27 Input Signal Filter Constant (P.60) ............................................................................................................. 94
5.43 The Second Frequency Source（P.97） ............................................................................................... 110
5.55 Proportion Linkage Function（P.185） ................................................................................................... 122
5.58 Input Signal across Terminal 2-5 (P.192~P.195) ....................................................................................... 125
5.59 Input Signal across Terminal 4-5 (P.196~P.199) ....................................................................................... 126
5.63 Auxiliary Frequency Function (P.240) ...................................................................................................... 131
(15) Misoperation preventation and frequency setting limit
5.26 The Choice of Locking Operation Keyboard Knob Setting (P.59) ............................................................. 94
5.33 Stop or Reset Function Selection (P.75） ................................................................................................. 100
5.34 Parameters Write Protection (P.77) ........................................................................................................... 101
5.35 Forward/Reverse Rotation Prevention Selection (P.78) ........................................................................... 101
5.57 Factory Setting Function (P.189) .............................................................................................................. 124
5.72 Password Protection Function (P.294 and P.295)
..................................................................................... 138
To Next Page
Loading...
Need help?
General
