5.2.3. Master/Slave Setup
The Pixel Controller supports master/slave control mode. You can connect the Pixelstrip 20/40 (max. 4 m
per output), Pixeltube 16/32 (max. 5 m per output) or PixelDots (max. 40 devices per output) to the Pixel
Controller. In the example below, the Pixelstrip 40 is connected to the Pixel Controller.
To connect multiple devices in master/slave setup, follow the steps below:
Connect the first device’s DMX OUT connector to the second device’s DMX IN connector with a 3-
pin/5-pin DMX cable.
Repeat step 1 to connect all devices as shown in Fig. 08.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device in the setup.
Set the first device on the data link as a master device. See 6.6.3.6. Slave on page 30 for more
information.
Set the remaining devices as slave devices. See 6.6.3.6. Slave on page 30 for more information.
To Next Page
Loading...
Need help?
General
