SHOWTEC Pixel User Manual

30
Pixel Controller
Product code: 44510
Slave
In this menu you can set the device as a slave.
01) When the display shows SLAVE, press the ENTER button to open the menu. The display will show:
02) Press the UP/DOWN buttons to select YES or NO. If you choose YES, the device will react the same as
the master device.
03) Press the ENTER button to confirm your choice.
Auto
In this menu you can run the desired built-in programs.
01) When the display shows AUTO, press the ENTER button to open the menu. The display will show:
02) Press the UP/DOWN buttons to select PROGRAM and press the ENTER button to confirm.
03) Press the UP/DOWN buttons to select one of the 30 built-in programs.
04) Press the ENTER button to confirm your choice.
05) Press the UP/DOWN buttons to select SPEED and press the ENTER button to confirm.
06) Press the UP/DOWN buttons to set the program speed. The adjustment range is 1–9, from slow to fast.
07) Press the ENTER button to save changes.

SHOWTEC Pixel Specifications

General

Channels	512
Weight	0.2 kg
DMX Channels	512
Control Protocol	DMX512
DMX Connectors	3-pin XLR
Storage Temperature	-20°C to 60°C