SHOWTEC Pixel User Manual

20
Pixel Controller
Product code: 44510
5.3.4. Art-Net Settings
To run your device using Art-Net protocol:
Configure the network address of your computer/lighting controller in the correct range (IP 2.x.x.x,
10.x.x.x or 192.168.x.x and Subnet 255.0.0.0). To change the IP address of the device, refer to 6.6.2.1.
Set Manual/DHCP on page 26 and 6.6.2.2. Set IP Address on page 26. To change the Subnet mask,
refer to 6.6.2.3. Set Net Mask on page 26. Make sure that all devices in the network have unique IP
addresses.
Note: Art-Net 4 supports both DHCP and static addressing.
Select Art-Net Protocol in the Set Net Protocol menu. See 6.6.3.4. Art-Net or 6.6.3.5. Kling-Net on
page 29.
Set the universe. See 5.3.6. Universe Numbering on page 21.
5.3.5. Kling-Net Settings
To run your device using Kling-Net protocol:
Install any Kling-Net-based software on your computer.
Make sure that your computer has a fixed IP address.
Select KlingNet IP in 6.6.2.1. Set Manual/DHCP on page 26. The Kling-Net-based software will
automatically configure the IP address of the device.
Select KlingNet Protocol in the Set Net Protocol menu. See 6.6.3.5. Kling-Net on page 29.
Map the device following the instructions of the Kling-Net-based software.

SHOWTEC Pixel Specifications

General

Channels	512
Weight	0.2 kg
DMX Channels	512
Control Protocol	DMX512
DMX Connectors	3-pin XLR
Storage Temperature	-20°C to 60°C