Signal Hold
In this menu you can determine the behaviour of the Pixel Controller in case of a DMX failure.
01) Press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to select one of the 2 options:
BLACK: If DMX signal is lost, the device will black its output out.
HOLD: If DMX signal is lost, the device will use the last successfully received DMX signal and will
continue using it until DMX signal reception is restored, in order to ensure undisrupted
performance.
03) Press the ENTER button to confirm your choice.
Pixel Reverse
In this menu you can set the pixel direction.
01) Press the UP/DOWN buttons to select one of the 2 options:
ON: Pixel direction reverse is enabled.
OFF: Pixel direction reverse is disabled.
02) Press the ENTER button to confirm your choice.
Screen Timeout
In this menu you can set the amount of time after which the display will turn off, when no button is
pressed.
01) Press the UP/DOWN buttons to select one of the 3 options: 30 seconds/60 seconds/NEVER.
02) Press the ENTER button to confirm your choice.
Screen Brightness
In this menu you can set the screen brightness.
01) Press the UP/DOWN buttons to select one of the 4 options: 25/50/75/100 %, from dark to brightest.
02) Press the ENTER button to confirm your choice.
Software Version
This menu shows the version of the currently installed software.
Invert Display
In this menu you can set the display inversion.
01) Press the UP/DOWN buttons to select one of the 2 options:
YES: Display inversion is enabled.
NO: Display inversion is disabled.
02) Press the ENTER button to confirm your choice.
Factory Reset
In this menu you can restore the default factory settings.
01) Press the UP/DOWN buttons to select one of the 2 options:
YES: Restore the default factory settings.
NO: Keep the current settings.
02) Press the ENTER button to confirm your choice.
To Next Page
Loading...
Need help?
General
