6.3.2 Route following options
Most of the route following options can be modied from map with no need to open Route's
page.
Inserting a Waypoint
During navigation you may want to rst reach another point on map, and only then navigate
to the initial destination.
To select a Waypoint put the cursor over the desired position and press [ENTER], in the
contextual menu select “Insert Waypoint” and press [ENTER]. If the WP function is available
in your function keys you can also put cursor on map on the desired position and press the
proper function key.
A route will be created connecting your current position, waypoint and nal destination.
Appending a Waypoint
When in navigation on an active route, you can also append a waypoint at the end of the route
by clicking anywhere on the map:
1. Place cursor on the desired location on the map and press [ENTER]
2. Select “Append WP” and press [ENTER]
Skipping a waypoint
If you want to skip current destination and to navigate to the next one in route:
1. Place cursor at the waypoint which is a current destination
2. Press [ENTER]
3. Select “Skip WP”
4. Press [ENTER].
Editing the list of waypoints
To quickly access the list of all waypoints of a route and get detailed information about it:
1. Place cursor over the waypoint on map
2. Press [ENTER]
3. Select “Open WP list”
4. Press [ENTER].
Deleting a waypoint or the entire route
You can delete entire route from map. If it is an active route (so that you navigate on it), rst
stop navigation in order to be able to delete it.
1. Place cursor at waypoint or route leg
To Next Page
Loading...
