The program will nd obstacles between two waypoints and re-build it so that obstacles
will be avoided. The program's decision about avoiding obstacles on your way is based on
information about your boat parameters (safe corridor, depth, height, length).
1. Place cursor on a route leg (a line, that connects two waypoints).
2. Press [ENTER]
3. Select “Easy routing”
4. Press [ENTER].
NOTE1 You must have an up-to-date C-Map 4D chart to use this option. This option is not
supported with MAX charts.
NOTE2 You must input correct information about your boat parameters in General Settings
– Ship Prole.
To Next Page
Loading...
