SICK deTec4 C4P-EA 3SC05 Series - 5 Mounting; Unpacking; Mounting the System Plug

5 Mounting
5.1 Unpacking
Approach
1.
Check the components for completeness and the integrity of all parts.
2. In the event of complaints, contact the responsible SICK subsidiary.
Further topics
•
"Or
dering information", page 87
5.2 Mounting the system plug
Overview
Y
ou must mount the system plug on the safety light curtain prior to starting mounting
and electrical installation work. Please note that depending on the application, the
system plug used at the sender may be different to that at the receiver.
Important information
DANGER
Hazard due to lack of effectiveness of the protective device
Malfunctions can occur if the safety light curtain is connected other than with one of
the system plugs provided.
►
Use the system plugs provided.
NOTICE
F
itting the system plug
If the system plug is not fitted, electrostatic discharge at the contacts may damage the
device.
►
Prevent electrostatic discharge at the contacts.
NOTICE
Enc
losure ratings IP 65 and IP67 only apply if the front connector is fitted.
If the system plug is not mounted, dirt, dust, or moisture may enter the device and
cause damage.
►
Fitting the system plug.
►
Prevent the entry of dirt, dust, and moisture.
Approach
1.
Make sure that the safety light curtain and system plug are disconnected from the
voltage supply while the system plug is being mounted.
2. Unpack the system plug.
3. Adjust the DIP switches as necessary.
4. Remove the protective film from the terminal compartment of the safety light
curtain.
5. Carefully mount the system plug on the terminal compartment of the safety light
curtain.
6. Use the 2 captive screws to screw the system plug onto the safety light curtain.
Torque 0.5Nm ±0.1Nm.
MOUNTING 5
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
41
Subject to change without notice