SICK deTec4 C4P-EA 3SC05 Series - Mounting the Upgrade Bracket

Figure 30: Mounting the FlexFix bracket to a device column (accessory)
Secure the sender and receiver in the bracket
1.
After assembling the FlexFix brackets, screw the sender or receiver into the FlexFix
brackets from the front.
2. Align the sender and receiver.
3. Use an M5 screw to secure the position of the sender and receiver in the FlexFix
bracket.
Torque: 2.5Nm to3Nm
Further topics
•
"Sender and r
eceiver alignment", page 62
5.3.3 Mounting the upgrade bracket
Overview
If an e
xisting C4000 safety light curtain is mounted with a swivel-mount bracket or with
a side bracket, it can be replaced with a deTec4 C4P-EAxxx3SC05 safety light curtain
using a replacement bracket. There is no need to drill new holes, since the existing
ones can be used for the replacement bracket.
Complementary information
A
dditional information for mounting a safety light curtain with a replacement bracket
can be found in the mounting instructions for the replacement bracket.
5 MOUNTING
50
O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05 8028570/2023-07-27 | SICK
Subject to change without notice