EasyManua.ls Logo

SICK deTec4 C4P-EA 3SC05 Series - Fault Indicators

SICK deTec4 C4P-EA 3SC05 Series
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LEDs Meaning
OSSD Field Diagnostics LEDs
1 2 3 4 5 6 7 8
Ö Y
el‐
low
The reset pushbutton is
de
fective or is being actu‐
ated continuously. Check
the wiring of the reset
pushbutton.
O R
ed Ö Yel‐
low
EDM warning: The EDM
in
put has no signal. Check
contactors and wiring.
Switch thevoltage supply
off and back on again.
o LED of
f. Ö LED flashes. O LED illuminates. Empty cells mean that the LED lights up, flashes, or is off.
If front screen contamination increases in ongoing operation, the laser alignment aid
s
witches on or the alignment takes longer than 3seconds, the receiver shows the
alignment quality again.
Further topics
"Indic
ation of the alignment quality", page 65
11.3.3 Fault indicators
Overview
In t
he event of a fault, the type of fault is indicated by the LED display on the sender or
receiver.
Sender
P
osition of the LEDs: see "Sender displays", page 17.
Table 27: Fault indication on the sender
LEDs Possible cause Troubleshooting
STATE Field
O Y
ellow o
Normal operation, no cable connec‐
t
ion between sender and receiver.
1)
O Y
ellow Ö Red
Fault in the voltage supply.
Chec
k the voltage supply, see
"Technical data", page 81.
Switch thevoltage supply off and
back on again.
If the fault persists, replace the
sender, see "Ordering informa‐
tion", page 87.
Ö Y
ellow Ö Red
The sender identified an internal
f
ault.
S
witch thevoltage supply off and
back on again.
If the fault persists, replace the
sender, see "Ordering informa‐
tion", page 87.
O R
ed ÖÖ Yellow/green
Reset of the configuration to factory
se
ttings is activated.
For additional information: see "Fac‐
tory settings", page 55.
O R
ed Ö Green
The device is in configuration mode
f
ollowing a change to the configura‐
tion.
For additional information: see "Con‐
figuration mode", page 57.
Ö Gr
een Ö Red
A problem occurred when resetting
t
he configuration to factory settings.
R
estart configuration, see "Fac‐
tory settings", page 55.
11 TROUBLESHOOTING
76
O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05 8028570/2023-07-27 | SICK
Subject to change without notice

Table of Contents

Related product manuals