SICK deTec4 C4P-EA 3SC05 Series - 7 Configuration; Overview; Factory Settings

7 Configuration
7.1 Overview
Important information
Table 15: Functions and their configuration type
Function Configuration type
Beam coding DIP switch
Set to factory settings
Restart interlock Automatic configuration
External device monitoring (EDM)
Application diagnostic output
Status indication on both sides
The following system plugs are available for configuring via a DIP switch:
•
SP1s
ystem plug
The SP1 system plug can be used on all of the senders and receivers of a single
system.
OFF
uncoded
code 1
code 2
rev.conf.
ON
1
O N
2
Figure 36: SP1 system plug with 2 DIP switches
Table 16: Overview of DIP switches
DIP switch Function
1, 2
•
Be
am coding, see "Configuring beam coding", page 57
•
Reset to factory settings, see "Reset to factory settings",
page 56
Further topics
•
"S
ystem plug", page 16
•
"Configuring the restart interlock", page 58
•
"Configuring external device monitoring (EDM)", page 59
•
"Status indication on both sides", page 60
7.2 Factory settings
Table 17: Configurable functions when delivered
Function Configuration when delivered
Beam coding. Uncoded
Restart interlock Not configured
External device monitoring (EDM) Not configured
CONFIGURATION 7
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
55
Subject to change without notice