Important information
DANGER
H
azard due to lack of effectiveness of the protective device
Persons and parts of the body to be protected may not be recognized in case of
non-observance.
►
Only mount deflector mirrors to solid walls or machine components. The position
of the deflector mirrors must not change after alignment.
►
Do not use deflector mirrors if contamination, beading water, condensation, or
frost on the deflector mirrors is to be expected.
►
Make sure that the deflector mirrors are intact and free of scratches, contamina‐
tion, beading water, condensation, frost, etc. at all times.
Further topics
•
"Mir
ror columns", page 97
15.6.2 Mounting
To mount the deflector mirrors, use the included swivel mount brackets.
15.6.3 Change in scanning range using deflector mirrors
Important information
NOTE
The use of deflector mirrors reduces the scanning range depending on the number of
deflector mirrors in the protective field.
Table 61: Scanning range with and without 1 or 2 deflector mirrors
Type Solution Scanning
ran
ge, typi‐
cal
Scanning range with
1deflector mirror, typi‐
cal
Scanning range with
2deflector mirrors, typi‐
cal
PNS75, PNS125 30mm 30m D1 + D2 ≤27m D1 + D2 + D3 ≤24.3m
15.6.4 Deflector mirror PNS75 - ordering information
Table 62: Ordering information for PNS75 deflector mirror
Mirror length in mm Max. protective field
hei
ght in mm
Type code Part number
340 300 PNS75-034 1019414
490 450 PNS75-049 1019415
790 750 PNS75-079 1019417
15.6.5 Deflector mirror PNS125 - ordering information
Table 63: Ordering information, deflector mirror PNS125
Mirror length in mm Max. protective field
hei
ght in mm
Type code Part number
340 300 PNS125-034 1019425
490 450 PNS125-049 1019426
790 750 PNS125-079 1019428
15 ACCESSORIES
96
O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05 8028570/2023-07-27 | SICK
Subject to change without notice
To Next Page
Loading...
