►
If nece
ssary, use a spirit level to check that the components are parallel. (6)
Further topics
•
"Minimum dis
tance from the hazardous point", page 23
•
"Minimum distance to reflective surfaces", page 25
•
"Sender and receiver alignment", page 62
•
"Alignment with the QuickFix bracket", page 64
•
"Alignment with the FlexFix bracket or with the upgrade bracket", page 65
5.3.1 Mounting the QuickFix bracket
Overview
2 Q
uickFix brackets are used to mount the sender and receiver.
The QuickFix bracket consists of 2 parts, which are pushed into each other. The two
individual parts are connected with an M5 screw and the housing (sender or receiver) is
clamped with form-fit clamping.
The two mounting surfaces for the brackets of the sender or receiver must be parallel
and lie in the same plane.
MOUNTING 5
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
45
Subject to change without notice
To Next Page
Loading...
