SICK deTec4 C4P-EA 3SC05 Series - System Connection (M12, 8-Pin)

Table 12: System connection pin assignment (male connector, M12, 5-pin)
Pin Wire color
1)
s S
ender r Receiver
1 Brown +24V DC (voltage supply
input)
+24V DC (voltage supply
input)
2 White In2
(
laser alignment aid push‐
button)
OSSD1 (switching output 1)
3 Blue 0V DC (voltage supply
in
put)
0V DC (voltage supply
input)
4 Black In1
(
laser alignment aid switch)
OSSD2 (output signal
switching device 2)
5
2)
Gray MFP1
N
ot assigned
MFP1
Not assigned
1)
Applies to the extension cables recommended as accessories.
2)
If the sender and the receiver are not connected, pin 5 can remain unassigned for a single system and,
f
or example, a 4-pin cable with a 4-pin female connector can be used.
Further topics
•
"Int
egration in electrical control", page 30
6.3 System connection (M12, 8-pin)
7
6
8
5
4
2
3
1
Figure 34: System connection (male connector M12, 8-pin)
T
able 13: System connection pin assignment for SP1 system plug (M12 male connector, 8-pin)
Pin Wire color
1)
s S
ender r Receiver
1 White Not assigned In3
RES (reset pushbutton
input)
2 Brown +24VDC (voltage supply
in
put)
+24VDC (voltage supply
input)
3 Green Not assigned MFP3
ADO (application diagnostic
output)
4 Yellow Not assigned In4
EDM (e
xternal device moni‐
toring input)
5 Gray In2
(
laser alignment aid push‐
button)
OSSD1 (switching output 1)
6 Pink In1
(
laser alignment aid switch)
OSSD2 (output signal
switching device 2)
7 Blue 0V DC (voltage supply
in
put)
0V DC (voltage supply
input)
8 Red MFP1
N
ot assigned
MFP1
Not assigned
1)
Applies to the extension cables recommended as accessories.
ELECTRICAL INSTALLATION 6
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
53
Subject to change without notice