SICK deTec4 C4P-EA 3SC05 Series - Page 75

Table 26: LEDs on the receiver during normal operation
LEDs Meaning
OSSD Field Diagnostics LEDs
1 2 3 4 5 6 7 8
O
W
hite
EDM is configured.
O
White
Beam coding 1 or 2 is
conf
igured.
O
W
hite
Restart interlock is config‐
ur
ed.
Ö Y
el‐
low
The receiver has recog‐
ni
zed beams from several
senders.
Remedial measures:
►
Check the distance to
senders of the same
design.
►
Check the beam cod‐
ing of the receiver and
systems in close prox‐
imity.
►
Make sure that light
beams from a differ‐
ent sender cannot
hit the receiver (excep‐
tion: when one of
the two systems uses
code1 and the other
uses code2), see "Pro‐
tection against inter‐
ference from systems
in close proximity to
each other", page 27.
O R
ed Ö Ö
Y
ellow/
green
o o o o o o o o
Reset of the configuration
t
o factory settings is acti‐
vated.
O R
ed Ö
Green
The device is in configu‐
r
ation mode following a
change to the configura‐
tion.
O R
ed O
Green
The laser alignment aid of
t
he sender is switched on.
Its own protective field is
clear.
O R
ed O Red
Its own protective field is
int
errupted.
OR
The protective field is
clear.
The reset button has just
been actuated.
O R
ed Ö Yel‐
low
The protective field is
c
lear.
Reset required.
TROUBLESHOOTING 11
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
75
Subject to change without notice