SICK deTec4 C4P-EA 3SC05 Series - Page 49

Secure the sender and receiver in the bracket
1.
After assembling the FlexFix brackets, screw the sender or receiver into the FlexFix
brackets from the front. (1)
2.
Align the sender and receiver. (2)
3. Use an M5 screw to secure the position of the sender and receiver in the FlexFix
bracket. (3)
Torque: 2.5Nm to3Nm
1 2 3
Figure 29: Inserting the safety light curtain in the FlexFix brackets
NOTE
T
he protective device can only be screwed in when both brackets are in alignment.
Recommendation:
1. Only hand-tighten the screws on the brackets at first.
2. Align the two brackets. To do this, place a straightedge or spirit level, for example,
on the screw mounting surfaces of the brackets that are not being used.
3. Tighten the screws.
Further topics
•
"Sender and r
eceiver alignment", page 62
•
"Brackets", page 88
5.3.2.2 Mount FlexFix bracket to the back of a device column
Overview
T
he FlexFix bracket can be mounted in the device column using sliding nuts.
Use washers between the FlexFix brackets and the device column if you want to mount
the sender and receiver in the center of the device column.
MOUNTING 5
8028570/2023-07-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05
49
Subject to change without notice