SICK deTec4 C4P-EA 3SC05 Series - Page 48

NOTE
T
he FlexFix mounting kit (part number 2073543) contains 2 FlexFix brackets, one
alignment tool, and the required screws, sliding nuts, and washers.
Further topics
•
"Br
ackets", page 88
5.3.2.1 Mounting the FlexFix bracket on a machine or profile frame
Important information
NOTE
W
hen selecting the screw length, the wall thickness of the FlexFix bracket must be
taken into account.
Mounting the FlexFix bracket on a machine or profile frame
T
able 11: Lateral and rear mounting with the FlexFix bracket
Mounting
me
thod
Description
On the side With the M5 screw through the FlexFix bracket on the machine or profile
frame. A screw nut or threaded hole is required on the machine or profile
frame (1).
With the M5 screw through the FlexFix bracket on the profile frame. 2 sliding
nut
s are required on the profile frame (2).
On the back With the M5 screw through the FlexFix bracket on the machine or profile
fr
ame. A screw nut or threaded hole is required on the machine or profile
frame (3).
Tightening torque: 5Nm…6Nm
1
2
3
Figure 28: Mounting the FlexFix bracket to a profile frame
5 MOUN
TING
48
O P E R A T I N G I N S T R U C T I O N S | deTec4 C4P-EAxxx3SC05 8028570/2023-07-27 | SICK
Subject to change without notice