SICK DME5000 User Manual

Operating Instructions Chapter 7
DME5000
8009813/ZJV1/2017-05 © SICK AG • Germany • Subject to change without notice 97
Menu Structure
Speed
MF2 is used as speed switching output. Active when "Limit" is exceeded.
The switching hysteresis is fixed at ± 0.1 m/s.
Active Inactive
Limit
Range
0.0 … 9.9 m/s
Speed > Limit Speed < Limit
Sign
+/– Monitoring in both movement directions
+ Monitoring in movement direction "+"
(increasing distance)
– Monitoring in movement direction "-"
(decreasing distance)
Resolution
Setting the resolution affects the digital data interfaces only.
This parameter must not be changed in the Hiperface version. Changes to the resolution
are only made by the parameter 3.1.6 "Period Length".
Adjustable: 50 ... 5000 µm, default 100 µm (or 125 µm in the Hiperface version)
Offset
The offset value is added to the internally determined distance value and acts on all
outputs and the display.
Adjustable: ± 250 m
"0" is output via the SSI interface at a negative measured value.
If the preset function is active, the offset value is overwritten when the preset input is
triggered; also see section 13.1 "Preset".
Plausibility
This function verifies measured values for plausibility. Triggers when the light beam is
interrupted, Contamination or optical/electrical interferences. Plausibility error leads to
measured value output 0.
200 ms (Default) Normal Off
Error suppression by measured value
extrapolation for max. 200 ms; errors >
200 ms result in error output.
Error suppression for
1 internal measuring
cycle, error output if
the error is pending
for longer.
No verification of
plausibility, error
output only if
measurement is no
longer possible.
Temperature
Display of current internal device temperature.
Note
Note

SICK DME5000 Specifications

General

Brand	SICK
Model	DME5000
Category	Measuring Instruments
Language	English