SICK DUSTHUNTER C200 - Page 86

86
8011952/YWL2/3-0/2016-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
4 START-UP AND PARAMETER SETTINGS
Fig. 56: Menu structure for configuring analog outputs/inputs and setting the MCU variant
Setting the MCU variant
The following steps are required to set the MCU for the DUSTHUNTER C200 sender/
receiver unit to be connected (see “Assigning the MCU to the sender/receiver unit”,
page 68):
▸ Set the MCU to “Maintenance” mode, select the “MCU Variant” submenu and select the
type “DUSTHUNTER C”.