27
8011952/YWL2/3-0/2016-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER C200
Subject to change without notice
PRODUCT DESCRIPTION 2
2.2.4.4 Modules
1 Display module
Module to display measured values and status information and for configuration during
start-up, selection via operating buttons.
a) Displays
The graphic display shows two main measured values of a connected sender/receiver unit
selected at the factory or calculated values from the MCU (e.g., scaled dust concentration)
as bar charts. Alternatively, up to 8 single measured values of a sender/receiver unit can
be displayed (toggle with “Meas” button).
Fig. 14: LC-Display with graphic (left) and text (right) display)
b) Control buttons
Type Display
LED
Power (green) Voltage supply OK
Failure (red) Function fault
Maintenance request (yellow) Maintenance request
LC-Display
Graphic display (main screen)
● Dust concentration
● Transmission
● Opacity
● Extinction
● Scattered light intensity
Text display
Two measured values (see graphic display) and
8 diagnosis values (see “LC-Display menu
structure”, page 85)
Button Function
Meas
● Toggle between text and graphic display
● Display the contrast setting (after 2.5 s)
Arrows Select next/previous measured value page
Diag Display alarm or fault message
Menu Display of main menu and selection of submenus
To Next Page
Loading...
