SICK MLG-2 - Mounting; Distance between Lower Edge of Housing and First Beam; Applications - Replacement Involving MLG-1 and MLG-2

5 Mounting
5.1 Distance between lower edge of housing and first beam
The distance between the lower edge of the housing and the first beam is not the same
on the MLG-2 as on the MLG-1.
There are three different applications, which are illustrated in chapters “Application 1”,
“Application 2”, and “Application 3”. The choice of application depends on which MLG-1
is being replaced and on the new MLG-2. The following table lists suitable MLG-2 var‐
iants as replacements for certain MLG-1 variants. For additional information, siehe
Tabelle 3, Seite 5.
b
Remember to take account of the difference between the lower edge of the hous‐
ing and the first beam during planning and mounting.
■
Application 1: see "Application 1", page 12
■
Application 2: see "Application 2", page 13
■
Application 3: see "Application 3 (PROFIBUS or CANopen)", page 14
Table 9: Applications – Replacement involving MLG-1 and MLG-2
MLG-1 MLG-2 MLG-1 and MLG-2
Type code
Interface and connection type
Type code
Version and data interface
Application – Comparison of
first beam in relation to lower
edge of housing
MLGx-xxxxA8xx MLGxxA-xxxxBxxxxx Application 1
MLGx-xxxxC8xx MLGxxN-xxxxCxxxxx Application 3
MLGx-xxxxE2xx MLGxxN-xxxxUxxxxx
1)
Application 2
MLGx-xxxxE5xx MLGxxA-xxxxRxxxxx Application 1
MLGx-xxxxE8xx MLGxxA-xxxxRxxxxx Application 1
MLGx-xxxxF2xx MLGxxN-xxxxUxxxxx
1)
Application 2
MLGx-xxxxF5xx MLGxxA-xxxxRxxxxx Application 1
MLGx-xxxxF8xx MLGxxA-xxxxRxxxxx Application 1
MLGx-xxxxI2xx MLGxxN-xxxxUxxxxx
1)
Application 2
MLGx-xxxxI8xx MLGxxA-xxxxIxxxxx Application 3
MLGx-xxxxN8xx MLGxxA-xxxxBxxxxx Application 1
MLGx-xxxxP8xx MLGxxN-xxxxPxxx02 Application 3
MLGx-xxxxT2xx MLGxxN-xxxxUxxxxx Application 2
MLGx-xxxxT8xx MLGxxA-xxxxIxxxxx Application 1
1)
Remember to order the following additional item: the DOS-1205-G M12 female connector for the sender
(part number: 6009719).
MOUNTING 5
8020351.ZLW3/2017-05-03 | SICK T E C H N I C A L I N F O R M A T I O N | The MLG-2 as a replacement product for the MLG-1 and XLG
11
Subject to change without notice