SICK S3000 Cold Store

±7,5°
±7,5°
Figure 45: Adjustable bracket
NOTE
b
Dur
ing mounting and adjustment, observe the dimensional drawings "Dimensional
drawings", page 119 and figure 67.
b
Make sure that the scan line is at the correct height during mounting. The beam
exit height is specified on the dimensional drawing of the S3000 Cold Store (see
figure 66, page 119).
5.2.2 Information label Notes on daily check
b
Af
ter mounting the device, affix the supplied Notes on daily check information
label.
NOTE
•
Use onl
y the information label in the language that the operators of the
machine can read and understand.
•
Affix the information label so that it is clearly visible to all operators during
operation of the system. After attaching additional objects and equipment,
the information label must not be concealed from view.
5 MOUNTING
58
O P E R A T I N G I N S T R U C T I O N S | S3000 Cold Store 8012029/ZA20/2019-11-14 | SICK
Subject to change without notice