SICK S3000 Cold Store

7.4 Compatibility mode
Overview
T
o ensure compatibility, the S3000 safety laser scanners with firmware ≥ B02.41 can
be operated in compatibility mode.
Activate the compatibility mode in the device selection wizard in the CDS.
Figure 48: Compatibility mode
R
easons why you must activate the compatibility mode or the compatibility mode is
activated automatically by the CDS:
•
You are using one of the following devices in an EFI system:
°
S3000 Professional CMS
°
S3000 with firmware < B02.41 and serial number < 12210000
°
S3000 Standard, Advanced, Professional with an I/O module with serial num‐
ber < 12210000
°
S3000 Remote with an I/O module with serial number < 11240000
°
S300 Professional CMS
°
S300 Expert CMS
°
S300 with firmware < 02.10 and serial number < 12210000
°
S300 with system plug serial number < 12210000
•
You are configuring an S3000 with firmware < B02.41 and serial num‐
ber < 12210000.
•
You are configuring an S3000 Standard, Advanced, Professional with an I/O mod‐
ule with serial number < 12210000.
•
You are configuring an S3000 Remote with an I/O module with serial num‐
ber < 11240000.
•
You are using a safety laser scanner with a system plug in which a configuration is
saved that:
°
only supports the compatibility mode.
°
was configured in the compatibility mode.
°
was configured with a CDS version < 3.6.7.
•
You want to ensure newly configured devices can be replaced with old devices.
•
You want to replace old devices with new.
The table below shows the differences between the functions of the device variants in
the compatibility mode.
CONFIGURATION 7
8012029/ZA20/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | S3000 Cold Store
65
Subject to change without notice