SICK S3000 Cold Store

Table 10: Required compatibility mode with different firmware versions of the S3000 in an EFI
s
ystem with other safety laser scanners
Firmware S300 Standard S300 Standard S300 Advanced S300 Advanced S300 Professional S300 Professional S300 Professional CMS S300 Expert S300 Expert S300 Expert CMS
Firmware ≥ 02.10 < 02.10 ≥ 02.10 < 02.10 ≥ 02.10 < 02.10 < 02.35
1)
≥ 02.10 < 02.10
< 02.10
1)
S3000 Cold
Store
≥B02.41 X – X
C
X
C C
X
C C
1)
This variant supports exclusively the compatibility mode
C = C
ompatibility mode required
X = Compatibility mode not required
3)
– = EFI system not supported
Complementary information
NOTE
T
he S300 Mini does not support the compatibility mode. For EFI systems with the S300
Mini safety laser scanner, a device must be used that is not operated in the compatibil‐
ity mode.
Further topics
•
"Scope", pa
ge 7
7.5 System parameters
You can assign a name to the configured application as well as to the safety laser scan‐
ner(s). T
he names are saved in the devices after the configuration is transferred. The
name chosen may be, for example, the identifier for the vehicle, system or the machine.
You enter the application name and the names of the safety laser scanners used in the
CDS.
7.5.1 Application name
Overview
D
evices with unique application names can be “reserved” for specific tasks. A machine
maintenance person comparing exchanged devices with the configuration data saved in
the CDS will be notified that the application name does not match. The machine main‐
tenance person can then exchange these devices for those with the correct application
name.
3)
Mak
e sure that the serial number of the S300 system plug is > 12210000 and that the S3000 I/O module is current (S3000 Standard,
Advanced, Professional with I/O module with serial number > 12210000, S3000 Remote with I/O module with serial number
> 11240000).
CONFIGURATION 7
8012029/ZA20/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | S3000 Cold Store
67
Subject to change without notice