Siemens 6ES7 305-1BA80-0AA0 User Manual

Parameter sets of signal modules
A.3 Parameters of digital output modules
S7-300 Automation System Module data
Manual, 08/2006, A5E00105505-04
A-5
Structure of data record 1
The figure below shows the structure of data record 1 for the parameters of digital output
modules.
You enable a parameter by setting a logic "1" at the corresponding bit of byte 0.
 
 
 
5HDFWLRQWR&386723
6XEVWLWXWLRQYDOXH
6XEVWLWXWLRQYDOXH
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
+ROGODVWYDOLGYDOXH
6HWVXEVWLWXWLRQYDOXH
'LDJQRVWLFVLQWHUUXSWHQDEOH
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
,QMHFWVXEVWLWXWLRQYDOXHLQWRFKDQQHO
QRWUHOHYDQW
%\WH
%\WH
%\WH
%\WH
Figure A-2 Data record 1 for parameters of digital output modules
Note
The "hold last valid value" and "set substitution value" parameters should only be enabled at
byte 0 as an alternative.

Siemens 6ES7 305-1BA80-0AA0 Specifications

General

Brand	Siemens
Model	6ES7 305-1BA80-0AA0
Category	Controller
Language	English