Safety instructions and standards
2.4 Operating conditions
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
39
TÜV
The TÜV confirms that the HMI device satisfies the requirements of the following standards
with regard to its safety functions.
Standard Title Version
DIN EN 60204-1 Safety of machinery – Electrical equipment of
machines – Part 1: General Requirements
01.10.2009
DIN IEC 62061 Safety of machinery – Functional safety of electrical,
electronic and programmable control systems for
machinery
01.04.2009
IEC 61508-1 to 4 Safety Integrity Level 3 01.01.2005
ISO 13850 Safety of machinery - EMERGENCY STOP -
Principles for design
01.01.2009
ISO 13849-1 Performance Level e and Category 4 01.09.2009
Additional measurements
Additional measurements were made for:
● Japan
– Table/Annex No 43,44,45 – Test Method for Radio Equipment mentioned in
Certification Regulations Article, Item 19, 19-2, 19-3 and 19-3-2
– Table/Annex No 47 – Test Method for Radio Equipment mentioned in Certification
Regulations Article, Item 19-5 and 19-11
– RFID – ARIB STD T-82
● Taiwan
– LP0002
2.4 Operating conditions
The national approvals for the HMI device are listed on the back of the device and in the
product information for "Wireless Teach Pendant F IWLAN V2" in the Internet
(http://support.automation.siemens.
com/WW/view/en/30360848/13330
0).
NOTICE
Wireless control device
A wireless control device may cause interference.
If a wireless control device is used, the following must be ensured:
That other systems at the site are not disturbed by the wireless control device
That other systems at the site do not disturb the wireless control device
To Next Page
Loading...
