Mounting and connection
4.5 Connecting the HMI device
Wireless Teach Pendant F IWLAN V2
72 Operating Instructions, 08/2010, A5E02453837-01
4.5.6 Replacing and charging the main rechargeable battery
4.5.6.1 Safety instructions
CAUTION
Charging and discharging the rechargeable battery
There is a risk of fire and, in extreme cases, explosion in the following situations!
Incorrect charging and discharging of the rechargeable battery
Reverse polarity
Short-circuit
Only charge the rechargeable battery in the HMI device or in a charger approved for the
HMI device.
Contact with battery fluid
If used incorrectly, fluid can leak from the battery.
Avoid contact with the battery fluid. If battery fluid comes in contact with skin, rinse it off
with water. If battery fluid comes into contact with the eyes, seek medical advice.
NOTICE
Use only approved batteries
If you use non-approved batteries, malfunctions may occur as a result.
Only use batteries that are approved for the HMI device.
Fully charge the main rechargeable battery before first use
If you attempt to use a main rechargeable battery in the HMI device in its factory state, the
HMI device will not start.
Fully charge the main rechargeable battery before inserting it in the HMI device.
Note
The following applies to lithium-ion rechargeable batteries:
Do not crush
Do not heat or burn
Do not short-circuit
Do not disassemble
Do not immerse in liquids – the rechargeable battery may rupture or burst
Store unused rechargeable batteries away from the following items which can cause the
contacts to be bridged.
These include:
– Paper clips
– Coins
– Keys
– Nails
– Screws or other small metal objects
To Next Page
Loading...
