Mounting and connection
4.6 Switching on and testing the HMI device
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
81
4.6 Switching on and testing the HMI device
When the HMI device is initially put into operation, there is no project. Ethernet is set as the
data transfer channel.
Requirement
● A charged main rechargeable battery is inserted in the HMI device.
Procedure
Proceed as follows:
1. Briefly press the "ON/OFF" button.
The "PWR" LED lights up – see section "LED display (Page 85)". The display then lights.
A progress b
ar is displa
yed during startup.
The loader is displayed once the operating system has started.
If a charged main rechargeable battery is inserted, the "BAT" LED lights up. The HMI
device automatically switches to "Transfer" mode if the following two requirements are
met:
– No project is loaded on the device.
– At least one data channel has been configured.
The following dialog appears:
2. Press the "Cancel" button.
The transfer is canceled. The Loader appears.
To Next Page
Loading...
