Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
47
Planning the use
3
3.1 Checklist
Perform the following tasks when planning fail-safe operation. Confirm each task by
checking it off in the following list.
Task Additional information Check
Check the ambient conditions at the
site.
Operating conditions (Page 48)
Plan access routes to the plant. –
Plan operator locations at the plant
where WLAN will be needed.
WLAN properties (Page 51)
Plan the WLAN.
Determine the installation locations
for the access points based on this.
Special programs are available for
planning the WLAN.
We strongly recommend you check
the local wireless conditions before
beginning start-up.
System manual "Basics on Setting up an Industrial
Wireless LAN"
(http://support.automation.siemens.com/WW/view/en/
9975764)
"SINEMA E" planning program
(http://www.siemens.com/sinema
)
Guideline for the Use of Industrial Wireless LAN in a
PROFINET IO Environment
(http://support.automation.siemens.com/WW/view/en/
31938420)
Plan for information security. Planning information security (Page 59)
Plan the configuration of the
PROFINET and PROFIsafe
communication.
System manual "Communication with SIMATIC"
(http://support.automation.siemens.com/WW/view/en/
25074283)
Programming and operation manual "S7 Distributed
Safety - Configuring and Programming"
(http://support.automation.siemens.com/WW/view/en/
22099875)
Plan the installation locations for the
RFID tags.
Planning an installation location for RFID tags
(Page 54)
Plan the installation location and
clearance for the docking station.
Planning the installation location and clearance of the
docking station (Page 56)
Plan the location for the signal
lamps.
Planning the installation location of signal lamps
(Page 57)
To Next Page
Loading...
