Siemens FC2005 Programming Manual

Programming Manual of FC2005/FC901
60|63 A6V10333724_b_en_--
user selects Stub A in the tool, the device must connect to
Stub A (primary port) as well on the panel, otherwise, error
occurs. It doesn’t matter if the wiring style is Class A.
FT2007:
System LED
Name Name of the device
Name Addition Addition description of the device; max. 20 characters
System LED List Reset, Acknowledge (default), Silence, Audibles On, Trouble,
Ground Fault
FT2007:
Input
Name Name of the device
Name Addition Addition description of the device; max. 20 characters
InputType Generic (default), System Input
Button List Only available when System Input is selected for InputType:
Reset (default), Acknowledge, Silence\Unsilence, Lamp Test
FT2008
FT2009
FT2018
FT2019
Name Name of the device
Name Addition Additional description of the device; max. 20 characters
Address Range: 1...8; System assigns one address automatically once a
device is added.
Local device Bool: True / False (default)
Location Option: Stub A, Stub B
When the wiring style of UFP line is selected as Class B, then if
user selects Stub A in the tool, the UFP device must be installed
on the Stub A (primary port) on the panel, otherwise, the UFP
device will not be detected by the panel. It doesn’t matter if the
wiring style is Class A.
UFP annunciator Name Name of the device
Address Addition description of the device; max. 20 characters
Report Alarm Bool: True (default) / False
Report Supervisory Bool: True (default) / False
Report Trouble Bool: True (default) / False
Report Status Bool: True (default) / False
Location Option: Stub A, Stub B
When the wiring style of UFP line is selected as Class B, then if
user selects Stub A in the tool, the UFP device must be installed
on the Stub A (primary port) on the panel, otherwise, the UFP
device will not be detected by the panel. It doesn’t matter if the
wiring style is Class A.
Printer Name Name of the device
Address Addition description of the device; max. 20 characters
Supervision Bool: True (default) / False
Report Alarm Bool: True (default) / False
Report Supervisory Bool: True (default) / False
Report Trouble Bool: True (default) / False
Report Status Bool: True (default) / False
Location Option: Stub A, Stub B
When the wiring style of UFP line is selected as Class B, then if
user selects Stub A in the tool, the UFP device must be installed

Siemens FC2005 Specifications

General

Brand	Siemens
Model	FC2005
Category	Control Panel
Language	English