Operation
5
139
Building Technologies A6V10380629_en--_a
Fire Safety 2015-09-10
7. Press 'Execute commands' on the dialog window toolbar.
a The 'Select command' dialog window opens.
8. Select the 'Control test' command.
a The command execution display confirms successful execution of the
command by displaying .
a The control test is performed.
Ending a control test
1. Repeat steps 1 - 7 of the instruction: Test a control.
a The 'Select command' dialog window opens.
2. Select the 'Control test END' command.
a The command execution display confirms successful execution of the
command by displaying .
a The control test is at an end.
To Next Page
Loading...
