5
Operation
Switching between 'Manned' / 'Unmanned' operation modes
122
Building Technologies A6V10380629_en--_a
Fire Safety 2015-09-10
Sabotage evaluation ON
1. Repeat steps 1 – 6 of the instruction 'Sabotage evaluation OFF'.
a The 'Select command' dialog window opens.
2. Select the 'Sabotage evaluation ON' command.
a The command execution display confirms successful execution of the
command by displaying .
a Sabotage evaluation is switched on.
5.4 Switching between 'Manned' / 'Unmanned'
operation modes
The 'Manned operation' or 'Unmanned operation' operation modes have an impact
on the processing of 'ALARM' and 'Fault'.
You can tell the operation mode set from the 'Manned/unmanned states' in the
system tabs.
Symbol Function
The operation mode is set to 'Manned operation'.
The operation mode is set to 'Unmanned operation'.
Switching the operation mode with standard button
w On the FT2080, there is a standard button with the 'Premises manned'
command.
1. Press the 'Premises manned' standard button on the PMI.
a The PIN input dialog is indicated.
2. Enter your PIN and confirm with 'ok'.
a The operation mode has been switched.
a Check the setting on the button 'Manned/unmanned states'.
To Next Page
Loading...
Need help?
General
